Summit TDC111V Service Manual Manual do Utilizador

Service ManualTumble Dryer - TD70.C

Article no. Component Measurement value Comment80 824 92 Heating element 1950 W Heater 1: 1950 W, 24.5 Ω80 915 90 Heating element 2500 W Heater 1: 195

Component descriptionComponents and function descriptionHere we describe the function and specification of the most important components. Certain compo

Cover plate (658 x 483 mm)Tolerance: ±1% Thermostat and overheating cut-outThe thermostat is installed next to the heating

Component descriptionPersonal notesDoor switchThe door switch is located in a holder in the middle of the front support and is activated by a pin in t

Component description Heating elementThe heating element is located in the rear section and consists of two separate heating coils. Each heating coil

Service Manual TD70.C15

Control unitCircuit diagram TD70.CThis document must not be copied withoutour written pemission, and the contentsthereof must not be imparted to a thi

This document must not be copied withoutour written pemission, and the contentsthereof must not be imparted to a third partynor be used for any unauth

Control unitCircuit diagram TD70.C MarineWIRES IN SOME MACHINESINTERNAL CONNECTIONNTC 1EL 1050 WFAPEL 1950 WT2DBFBL1L2MOT1NTC 2 *AWIRES IN ALL MACHINE

This document must not be copied withoutour written pemission, and the contentsthereof must not be imparted to a third partynor be used for any unauth

Control unitCircuit diagram TD70.C UL (only USA)This document must not be copied withoutour written pemission, and the contentsthereof must not be imp

This document must not be copied withoutour written pemission, and the contentsthereof must not be imparted to a third partynor be used for any unauth

Control unitCircuit diagram TD70.C HWCThis document must not be copied withoutour written pemission, and the contentsthereof must not be imparted to a

This document must not be copied withoutour written pemission, and the contentsthereof must not be imparted to a third partynor be used for any unauth

Circuit diagram TD70.C HPControl unitWIRES IN SOME MACHINESINTERNAL CONNECTIONNTC 1FAPDBFBNL1L3L2CM6CM5CM3INKBCM2MOCM4CM1NTC 2WIRES IN ALL MACHINESCAB

This document must not be copied withoutour written pemission, and the contentsthereof must not be imparted to a third partynor be used for any unauth

Fault indicatorsIn the case of a fault the following fault indicators are shown on the display. TroubleshootingS3J1 DISPLAYS2S1Display Cause ActionOve

Display Cause ActionThermistor fault, Thermistor Fault, Thermistor fault, Termistorfel, Termostat fejl, Termistor, Termistorivika, Défaut , Termistorf

Fault symptom Cause ActionThe machine will not start.The outer door is not properly closed. • Check that the door pin is activating the door switch.Th

Fault symptom Cause ActionThe machine is leaking water.Improper installed auto filter and/or sealingInformation to customer:• Check that the auto lter

Updates ...

Service menuTurn/PushDisplay Comments/instructionsSP: xxxx Date the software was programmed (Year_Week)TRACKING DATACM: xxxx Date of manufacture of th

Service menu cont.Turn/PushDisplay Comments/instructionsTest No component testedDIAGNOSTICSTest motor The motor runs at normal speedTest heater 1 The

Service menu cont.Turn/PushDisplay Comments/instructionsFilter Interval 2 Interval for indication ”Clean filter”, default setting (every 2nd cycle)CLE

Service menu cont.Turn/PushDisplay Comments/instructionsCondense Interval 0 Interval for indication ”Clean condense”, default setting (not shown)CLE

Service and installationDismount top cover and back rearInstructions Illustration1. Unscrew the top cover.2. Dismount the panel rear cover by removing

Service and installationDismount top cover and back rear cont.Instructions Illustration6. Disconnect the rubber hose.7. Remove the screws on the rear

Service and installationInstructions Illustration1. Attach the anti-static wristband to a part of the machine that is earthed!NOTE! An anti-static wri

Instructions Illustration6. Carefully pull the programme selector from the panel.7. Use a screwdriver to free the control card from the panel. NOTE! T

Service and installationTransporting a tumble dryer with a heat pumpMachines with a heat pump must only be transported upright or placed on the left s

Personal notesService Manual TD70.C39

UpdatesRev Date Description Initials01 2011-09-06 First version FH02 2011-11-16 New document structure ISC03 2012-01-20 New revision circuit diagram E

We reserve the right to make changes.www.asko.com80 925 40 Rev08 2012-09-17

IntroductionYou are holding the Service manual for the TD70 tumble dryer. The TD70 tumble dryers is available in several models, designated TD70.1, TD

Troubleshooting strategyTroubleshooting is an important part of the service callout, and as such we have drawn up a troubleshooting strategy that desc

Product overviewTD70.CProgrammes: A total of 7 programmes.Settings: 4 settings (Language, Child-safe, Buzzer, Heater 2)S3J1 DISPLAYS2S1Knob and butto

Technical informationHeight 850 mmWidth 595 mmDepth 585 mmWeight 43 kg (Vented)47 kg (Condenser)55 kg (Heat pump)44 kg (Heating Water Circuit)Cylinder

Component descriptionComponents and measurement valuesThe specified resistance values apply at room temperature (about 20°C/68°F). Values within ±10% a