Summit SBC635MSSTB Manual

COMMERCIAL BEER DISPENSER Model SBC635M Use and Care Guide Felix Storch, Inc. 770 Garrison Avenue Bronx, NY 10474 www.summi

9 d) Place the CO2 tank and CO2 regulator valve component into the cabinet and fix the CO2 tank with tank bracket and bolt (See Figure 8). 4. Ins

10 OPERATION The control panel is located just above the door, and looks like this: Control Panel Adjust the DOWN or UP button on the control

11 There is usually no need to defrost the beer dispenser because the ice deposited on the inner back wall is automatically defrosted. Ice deposits

12 5. Hold the glass steady at a 45° angle. When it is 2/3 full, start straightening the glass. Proper foam should be a tight, creamy head and the

13 MAINTENANCE OF THE BEER DISPENSER To optimize cooling and to save energy at the same time, dust the back of the beer dispenser periodically. Clean

14 DISPOSING OF A WORN-OUT APPLIANCE • When your appliance finally wears out, dispose of it. • Before you dispose of an old appliance: Take the do

15 DRAFT BEER TROUBLESHOOTING Problem Cause Correction Beer is cloudy: The beer in the glass appears hazy and not clear. Excessively low temperature

16 Beer has off taste: Often bitter and bite-y; sometimes completely lacking flavor and zest. It may also have an oily or foul odor which may carry a

17 GENERAL TROUBLESHOOTING If there is a problem with the beer dispenser itself, see if you can find it listed in the chart below. You may be able t

18 NOTES

1 TABLE OF CONTENTS Important Safeguards ... 2 – 3 Location of P

19 LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained

2 IMPORTANT SAFEGUARDS WARNING! To reduce the risk of fire, electric shock or injury when using this appliance, follow these basic precautions: 1. R

3 5. Be sure the plug fits firmly into the socket and that the socket is grounded. 6. The use of an extension cord is NOT recommended. 7. The beer di

4 LOCATION OF PARTS BEFORE USING FOR THE FIRST TIME The SBC635M is designed for dispensing beer only, and is not recommended for stori

5 PLACEMENT AND INSTALLATION To ensure that your beer dispenser works at the maximum efficiency it was designed for, install it in a location where t

6 Reversing the Door Swing Figure 1 (Default position) Figure 2 (After door reversal) 1. Upper h

7 Installation of Accessories Diagram of overall structure Installation components Installation steps 1. Install universal whe

8 installed these rear wheels will keep the unit from moving if you step on the foot brakes (See Figure 2): 2. Install the beer tower assembly