Summit CR2110 Manual do Utilizador

INSTRUCTION MANUAL for Ceramic Glass Electric Cooktop Models CR1115 CR2110 CR2220 CR3240 Fe

9 NOTE: BE CAREFUL NOT TO OVERTIGHTEN THE SCREWS. NOTE: Cooktop carrier brackets have already been installed on your cooktop.

10 Step #5 Electrical Connection Before proceeding further, verify that the power supply is disconnected. Verify that the appropriate e

11 SAFETY INSTRUCTIONS Read this section BEFORE operating the cooktop. This cooktop, like all appliances, has the potential to create safety pro

12 • Do not cook on a broken cooktop. If your cooktop should break, cleaning solutions and spillovers may penetrate the broken cooktop and create a

13 Operation READ SAFETY INSTRUCTIONS BEFORE OPERATING YOUR APPLIANCE. The cooking surface areas of your glass ceramic cooktop are identified by

14 Controls & Indicators Each of the cooking area controls has an infinite selection of heat settings. The control settings begin at low and

15 ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance

1 Table of Contents Product Specifications ...2 Installation I

2 Product Specifications Single Burner CR1115: 120V AC – one 6” (140 mm) burner @ 1200 watts Overall dimensions: 11⅞”W x 12⅝”D x 3⅜”H

3 Contour Cooktop Installation Instructions for Ceramic Glass Cooktops Step #1 Unpacking the Cooktop Carefully unpack the cooktop from its

4 Step #2 Check the Electrical Supply Requirements This product must be installed in accordance with national, state and local electric codes. The

5 Step #3 Countertop Preparation Please read this section prior to making cutout for the cooktop. It is important to plan ahead for installa

6 Adequate ventilation of the space below the countertop must be provided to ensure proper operation of the cooktop. Heat transferred from

7 Summary of Cutout Dimensions Model Width Depth CR1115 11⅛" 11⅞" CR2110, CR2220 11⅛" 19⅛" CR3240

8 Step #4 Installing the Cooktop 1. Strips of foam sealant have already been installed around the outer edge of the underside of the